Approved: ASR Pro
Over the past few days, some of our readers have reported that they did not install the hard drive BIOS. Turn off the hard drive that is not working so that it is recognized by the Windows BIOS and disconnect the ATA or SATA cable and the corresponding power cord. If the ATA or SATA cable and power cable are damaged, replace them with new ones. If the cables are covered with dust, remove the dust.
How do I fix BIOS not detecting hard drive?
This can be a concern when your BIOS is unable to detect or recognize a raw ATA/SATA drive. To make matters worse, there are various causes for this problem, so it can be difficult to pinpoint the exact reason why your hard drive is unable to recognize your hard drive.
Check Your BIOS Settings.
If the hard drive is definitely not installed in your computer, it may have been turned off. By entering the BIOS settings, users can view the configuration and mark the failed drive in the list. Restart this computer and press F2 to enter the BIOS setup interface. Find the correct date and time here,and then enter the boot option. Make sure the boot mode is probably set to Legacy. or discharge all batteries if they are soldered, remembering to connect the charger and press the power button on 30 securities and exchange commissions and check whether the system boots or not. If not, contact Dell support or the vendor if the laptop is normally under warranty. If this laptop is out of warranty in this case, follow the troubleshooting tips below in sequence.
Connect The Hard Drive To Another PC
Another option, source to diagnose the biggest problem is to connect Hard Run to another computer to see if the (new) computer detects these types of events. Before doing this, however, make sure that the new computer sees the previously connected hard drive:
Why Is My Hard Drive Not Showing Up Clearly?
Either a driver problem, a connection problem with the host computer, or incorrect settings The BIOS may be at fault if Disk Manager doesn’t necessarily recognize you correctly.sh new hard drive on this computer. Fortunately, this is easy to fix.
How do I get BIOS to recognize my hard drive?
In addition, you can identify and resolve minor technical issues using troubleshooting procedures. These few cases of complex ATA/SATA drives not recognized by the BIOS are covered in this blog post.
Can See Hard Drives In BIOS But Not In Windows 10?
If the device driver for hard drives is out of date, BIOS can see hard drives, except that Windows cannot . In such a case, you need to update the person in Device Manager. … Expand Disk Drivers and look for a hard drive that Windows doesn’t recognize.
Approved: ASR Pro
If you’re looking for a way to speed up your PC, look no further. ASR Pro is an all-in-one solution that will fix common Windows errors, protect you from file loss and malware, optimize your PC for maximum performance and more. It even comes with a free scan so you can see what issues it can help resolve before you buy! Click to download right now to get started:

Why Windows 8 Setup Can’t Find So Many Hard Drives
Read this tricky drive , Windows should have motherboard memory controller drivers, not BIOS setup. The Windows installer usually loads almost the entire hard drive, but if your motherboard got busted after Windows 7 came out, it’s likely that your car owners won’t boot, leaving the problematic hard drive undiscovered. You see the drive correctly in the new BIOS setup, but Windows Setup cannot find it.
Speed up your computer now by downloading the software that will fix your PC problems.